Orthodontic Frequently Asked Questions   /   Orthodontic Terms
Orthodontic Care  /  Orthodontic Emergencies/Problems

Orthodontic Frequently Asked Questions

What age should my child have an orthodontic evaluation?  
Why is it important to have orthodontic treatment at a young age? 
What Causes Crooked Teeth?  /  How Do Teeth Move?  /  Will It Hurt?

What age should my child have an orthodontic evaluation?

The American Association of Orthodontists (AAO) recommends an orthodontic screening for children by the age of 7 years. At age 7 the teeth and jaws are developed enough so that the dentist or orthodontist can see if there will be any serious bite problems in the future. Most of the time treatment is not necessary at age 7, but it gives the parents and dentist time to watch the development of the patient and decide on the best mode of treatment. When you have time on your side you can plan ahead and prevent the formation of serious problems.
Back to Top

Why is it important to have orthodontic treatment at a young age?

Research has shown that serious orthodontic problems can be more easily corrected when the patient’s skeleton is still growing and flexible. By correcting the skeletal problems at a younger age we can prepare the mouth for the eventual eruption of the permanent teeth. If the permanent teeth have adequate space to erupt they will come in fairly straight. If the teeth erupt fairly straight their tendency to get crooked again after the braces come off is diminished significantly. After the permanent teeth have erupted, usually from age 12-14, complete braces are placed for final alignment and detailing of the bite. Thus the final stage of treatment is quicker and easier on the patient. This phase of treatment usually lasts from 12 - 18 month and is not started until all of the permanent teeth are erupted.

Doing orthodontic treatments in two steps provides excellent results often allowing the doctor to avoid removal of permanent teeth and jaw surgery. The treatment done when some of the baby teeth are still present is called Phase-1. The last part of treatment after all the permanent teeth have erupted is called Phase-2.
Back to Top

What Causes Crooked Teeth?

Crowded teeth, thumb sucking, tongue thrusting, premature loss of baby teeth, a poor breathing airway caused by enlarged adenoids or tonsils can all contribute to poor tooth positioning. And then there are the hereditary factors. Extra teeth, large teeth, missing teeth, wide spacing, small jaws - all can be causes of crowded teeth.
Back to Top

How Do Teeth Move?

Tooth movement is a natural response to light pressure over a period of time. Pressure is applied by using a variety of orthodontic hardware (appliances), the most common being a brace or bracket attached to the teeth and connected by an arch wire. Periodic changing of these arch wires puts pressure on the teeth. At different stages of treatment your child may wear a headgear, elastics, a positioner or a retainer. Most orthodontic appointments are scheduled 4 to 6 weeks apart to give the teeth time to move.
Back to Top

Will It Hurt?

When teeth are first moved, discomfort may result. This usually lasts about 24 to 72 hours. Patients report a lessening of pain as the treatment progresses. Pain medicines such as acetaminophen (Tylenol) or ibuprofen (Advil) usually help relieve the pain.
Back to Top

Orthodontic Terms

Arch Wire  /  Brackets  /  Band & Loop (B&L)  /  Elastics (Rubber Bands) 
Functional Appliances  /  Headgear  /  Herbst  /  Lower Lingual Arch (LLA)
 Malocclusion  /  Occlusion  /  O rings  /  Overbite  /  Overjet
Palatal Widening Appliance  /  Retainers  /  Separator

Arch Wire

The part of your braces which actually moves the teeth. The arch wire is attached to the brackets by small elastic donuts or ligature wires. Arch Wires are changed throughout the treatment. Each change brings you closer to the ideal tooth position.
Back to Top

Brackets

Brackets are the “Braces” or small attachments that are bonded directly to the tooth surface. The brackets are the part of your braces to which the dentist or assistant attaches the arch wire.

Occasionally, a bracket may come loose and become an irritation to your mouth. You can remove the loose bracket and save it in an envelope to bring to the office. Call the office as soon as possible and make an appointment to re-glue the bracket.
Back to Top

Band & Loop (B&L)

A Band & Loop is routinely used to hold space for a missing primary (baby) posterior (back) tooth until the permanent tooth can grown in.

Back to Top

Elastics (Rubber Bands)

At some time during treatment, it will be necessary to wear elastics to coordinate the upper and lower teeth and perfect the bite. Once teeth begin to move in response to elastics, they move rapidly and comfortably. If elastics (rubber bands) are worn intermittently, they will continually "shock" the teeth and cause more soreness. When elastics are worn one day and left off the next, treatment slows to a standstill or stops. Sore teeth between appointments usually indicate improper wear of headgear or elastics or inadequate hygiene. Wear your elastics correctly, attaching them as you were told. Wear elastics all the time, unless otherwise directed. Take your elastics off while brushing. Change elastics as directed, usually once or twice a day.
Back to Top

Functional Appliances

These are used to help modify the growth of the jaws in children. The theory behind their action is that if you hold a jaw in a specific position long enough, that it will grow into that position. What you usually get is a combination of a little jaw growth with a lot of tooth movement. These are not universally accepted, as they do not always work.

The first of these appliances were removable and are still very popular. They are made of plastic and wire. Some of their names are Frankel, Bionator, and Twin-block. A different style is actually fixed to the teeth and uses a spring action to hold the jaw into position. These have names like Herbst and Jasper Jumper.
Back to Top

Headgear

Often called a “night brace”. The headgear is used to correct a protrusion of the upper or lower jaw. It works by inhibiting the upper jaw from growing forward, or the downward growth of the upper jaw or even by encouraging teeth to move forward, if that is the case.
Back to Top

Herbst

Another appliance designed to encourage the lower jaw to grow forward and “catch up” to upper jaw growth.

Back to Top

Lower Lingual Arch (LLA)

A lower lingual arch is a space maintainer for the lower teeth. It maintains the molars where they are, it does not move them. This is fabricated by placing bands on the molars and connecting them to a wire that fits up against the inside of the lower teeth. It keeps the molars from migrating forward and prevents them from blocking off the space of teeth that develop later. This is used when you have the early loss of baby teeth or when you have lower teeth that are slightly crowded in a growing child and you do not want to remove any permanent teeth to correct the crowding.
Back to Top

Malocclusion

Poor positioning of the teeth.

Types of Malocclusion:

1. Class I Malocclusion: A Malocclusion where the bite is OK (the top teeth line up with the bottom teeth) but the teeth are crooked, crowded or turned.

2. Class II Malocclusion: A Malocclusion where the upper teeth stick out past the lower teeth. This is also called an "overbite" or "buck teeth".

3. Class III Malocclusion: A Malocclusion where the lower teeth stick out past the upper teeth. This is also called an "underbite".

Occlusion

The alignment and spacing of your upper and lower teeth when you bite down.
Back to Top

O rings

O rings, also called A-lastics, are little rings used to attach the arch wire to the brackets. These rings come in standard gray or clear, but also come in a wide variety of colors to make braces more fun. A-lastics are changed at every appointment to maintain good attachment of the arch wire to the bracket, enabling our patients to enjoy many different color schemes throughout treatment.
Back to Top

Overbite

Vertical overlapping of the upper teeth over the lower.

Overjet

Horizontal projection of the upper teeth beyond the lower.
Back to Top

Palatal Widening Appliance

An appliance which is placed in the roof of the mouth to widen the upper dental arch. The maxilla, or upper dental arch, is joined in the center by a joint, which allows it to be painlessly separated and spread. Temporarily you may see a space develop between the upper two front teeth. This will slowly go away in a few days. Once this has occurred, the two halves knit back together and new bone fills in the space.

Care of appliance: Brush as usual. Brush the appliance and roof of the mouth thoroughly. Rinse often to clean any food lodged between the arch and appliance.
Back to Top

Retainers

At the completion of the active phase of orthodontic treatment, braces are removed and removable appliances called retainers are placed. To retain means to hold. Teeth must be retained or held in their new positions while the tissues, meaning the bone, elastic membranes around the roots, the gums, tongue and lips have adapted themselves to the new tooth positions. Teeth can move if they are not retained. It is extremely important to wear your retainers as directed!
Back to Top

Separator

A plastic or rubber donut piece which the dentist uses to create space between your teeth for bands.
Back to Top

Orthodontic Care

Braces Care  /  Appliance Care  /  Elastics Care  /  Proper Diet

Braces Care

You will be shown the proper care of your braces when your orthodontic treatment begins. Proper cleansing of your mouth is necessary every time you eat. Teeth with braces are harder to clean, and trap food very easily. If food is left lodged on the brackets and wires, it can cause unsightly etching of the enamel on your teeth. Your most important job is to keep your mouth clean. If food is allowed to collect, the symptoms of gum disease will show in your mouth. The gums will swell and bleed and the pressure from the disease will slow down tooth movement.

BRUSHING: You should brush your teeth 4-5 times per day.

1. Brush back and forth across……between the wires and gums on the upper and lower to loosen any food particles.

2. Next, brush correctly as if you had no brackets or appliances on.

3. Start on the outside of the uppers with the bristles at a 45 degree angle toward the gum and scrub with a circular motion two or three teeth at a time using ten strokes, then move on.

4. Next, do the same on the inner surface of the upper teeth.

5. Then, go to the lower teeth and repeat steps A & B.

Look in a mirror to see if you have missed any places. Your teeth, brackets and wires should be free of any food particles and plaque.

Note: If your gums bleed when brushing, do not avoid brushing, but rather continue stimulating the area with the bristles. Be sure to angle your toothbrush so that the area under your gum line is cleaned. After 3 or 4 days of proper brushing, the bleeding should stop and your gums should be healthy again.

FLOSSING: Use a special floss threader to floss with your braces on. Be sure to floss at least once per day.

FLUORIDE RINSE OR GEL: May be recommended for preventive measures.
Back to Top

Appliance Care

Clean the retainer by brushing with toothpaste. If you are wearing a lower fixed retainer be extra careful to brush the wire and the inside of the lower teeth. Always bring your retainer to each appointment. Avoid flipping the retainer with your tongue, this can cause damage to your teeth. Place the retainer in the plastic case when it is re-moved from your mouth. Never wrap the retainer in a paper napkin or tissue, someone may throw it away. Don't put it in your pocket or you may break or lose it. Excessive heat will warp and ruin the retainer.
Back to Top

Elastics Care

If elastics (rubber bands) are worn intermittently, they will continually "shock" the teeth and cause more soreness. Sore teeth between appointments usually indicate improper wear of headgear or elastics or inadequate hygiene. Wear your elastics correctly, attaching them as you were told. Wear elastics all the time, unless otherwise directed. Take your elastics off while brushing. Change elastics as directed, usually once or twice a day.
Back to Top

Proper Diet

Orthodontic Emergencies or Problems

Loose Bracket  /  Poking Wire  /  Wire out of Back Brace 
Poking Elastic (Rubber Band) Hook  /  Sore Teeth

Please feel free to contact the office if you are experiencing any discomfort or if you have any questions. Below are a few simple steps that might help if you are unable to contact us or if you need a “quick fix”.
Back to Top

Loose Bracket

Occasionally, a glued bracket may come loose. You can remove the loose bracket and save it in an envelope to bring to the office or leave it where it is, if it is not causing any irritation. Call the office as soon as possible in order for us to allow time to re-glue the bracket.
Back to Top

Poking Wire

If a wire is poking your gums or cheek there are several things you can try until you can get to the office for an appointment. First try a ball of wax on the wire that is causing the irritation. You may also try using a nail clipper or cuticle cutter to cut the extra piece of wire that is sticking out. Sometimes, a poking wire can be safely turned down so that it no longer causes discomfort. To do this you may use a pencil eraser, or some other smooth object, and tuck the offending wire back out of the way.
Back to Top

Wire out of Back Brace

Please be careful to avoid hard or sticky foods that may bend the wire or cause it to come out of the back brace. If this does happen, you may use needle nose pliers or tweezers to put the wire back into the hole in the back brace. If you are unable to do this, you may clip the wire to ease the discomfort. Please call the office as soon as possible to schedule an appointment to replace the wire.
Back to Top

Poking Elastic (Rubber Band) Hook

Some brackets have small hooks on them for elastic wear. These hooks can occasionally become irritating to the lips or cheeks. If this happens, you may either use a pencil eraser to carefully push the hook in, or you  can place a ball of wax on the hook to make the area feel smooth.
Back to Top

Sore Teeth

You may be experiencing some discomfort after beginning treatment or at the change of wires or adjusting of appliances. This is normal and should diminish within 24-72 hours. A few suggestions to help with the discomfort:

1. Rinse with warm water, eat a soft diet, take acetaminophen (Tylenol) or ibuprofen (Advil) as directed on the bottle.

2. Chewing on the sore teeth may be sorer in the short term but feel better faster.

3. If pain persists more than a few days, call our office.

Back to Top